subramaniyam
May 22nd, 2013, 08:35 AM
Hi all,
I just made a simple pen cradle which you can print on card or on paper, then stick on card, cut along dotted lines and assemble into a small pen cradle. You can get two pen cradles in one shot. I have made it in credit-card size (8X5 cm), so please print it at 100% (no scaling). I wasnt able to print it out and make one since I am travelling, so I will be glad if someone could do the initial beta testing. C & C will be welcome. :-)
I build a lot of paper models, so I got inspired while looking at a ship cradle that i had made. Hope it will be useful. Since it is card sized, you can carry a couple in your wallet while travelling, so you can use your clipless pens.
2880
2881
Instructions:
1. Cut along the dotted lines. DO NOT FOLD anywhere. Simply take your scissors or blade and cut along the dotted lines.
2. You will get eight pieces, which are numbered 1-8. Each will have two slots cut into them.
3. Take pieces 1, 2, 3, and 4.
4. Slot the pieces 3 and 4 perpendicular to the pieces 1 and 2, as shown in the pic.
5. Repeat with pieces 5-8.
6. You have two pen cradles. :-)
Please do not use this for commercial use. This is just a thank-you to all you wonderful ppl out there. :-)
Regards,
Subramaniyam
I just made a simple pen cradle which you can print on card or on paper, then stick on card, cut along dotted lines and assemble into a small pen cradle. You can get two pen cradles in one shot. I have made it in credit-card size (8X5 cm), so please print it at 100% (no scaling). I wasnt able to print it out and make one since I am travelling, so I will be glad if someone could do the initial beta testing. C & C will be welcome. :-)
I build a lot of paper models, so I got inspired while looking at a ship cradle that i had made. Hope it will be useful. Since it is card sized, you can carry a couple in your wallet while travelling, so you can use your clipless pens.
2880
2881
Instructions:
1. Cut along the dotted lines. DO NOT FOLD anywhere. Simply take your scissors or blade and cut along the dotted lines.
2. You will get eight pieces, which are numbered 1-8. Each will have two slots cut into them.
3. Take pieces 1, 2, 3, and 4.
4. Slot the pieces 3 and 4 perpendicular to the pieces 1 and 2, as shown in the pic.
5. Repeat with pieces 5-8.
6. You have two pen cradles. :-)
Please do not use this for commercial use. This is just a thank-you to all you wonderful ppl out there. :-)
Regards,
Subramaniyam