View Full Version : Section making question
Delum
April 3rd, 2020, 11:54 AM
Just starting trying to make my own sections. Do you always do the inside first? What is your fail rate?
Penultimate
April 4th, 2020, 06:17 PM
Hi
I tap the OD that goes into the body first. I found that the solid ID gives the tapping operation more stability. Then I drill and tap the ID.
Sent from my iPhone using Tapatalk
Penultimate
April 4th, 2020, 06:24 PM
If you are new to pen making have you checked out the International Association of Penturners , IAP.org?
It’s a great forum with amazingly talented pen makers. They are very welcoming. Check them out.
Sent from my iPhone using Tapatalk
FredRydr
April 4th, 2020, 07:33 PM
One of these days, a smart pen maker will offer parts fabricated by 3D printer.
Penultimate
April 11th, 2020, 07:27 PM
I’ve seen some printed parts. There is a pen maker that creates honeycomb patterns then casts over them. I’ve also seen pen sections.
Sent from my iPhone using Tapatalk
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.