Got my first Gold Seal today, in Lazulitic Blue, and Broad Flexible Personal Point

Was really hoping I got the immaculate condition Wahl gold-filled Colonial Ring with a #4 personal point nib too, but someone beat me to that one.

I wasn't able to pin-point this one down to an exact model in the 1929 catalog (and didn't see anything like it in the 1932 catalog), but far as I can tell it's a Personal Point Gold Seal, with a #4 personal point nib, that is a Broad Flexible nib.

https://i.imgur.com/RhnAabs.jpg

https://i.imgur.com/3ceThpG.jpg

https://i.imgur.com/P8g0QR2.jpg

https://i.imgur.com/cuo1S5f.jpg

https://i.imgur.com/EQLUyik.jpg

https://i.imgur.com/mntN8S3.jpg

https://i.imgur.com/If3a79q.jpg

https://i.imgur.com/9Y1FfaX.png

Nice. Great colour

Was going to give a writing sample, and after a few lines it starts dripping ink. I fear that the sac may be ruptured or not sealed somewhere on the nipple despite being sold "The pen has been restored and takes a nice fill."

https://www.youtube.com/watch?v=2xNyChK0fmQ

Edit:

https://youtu.be/TCnSS9sGAcU

Best I can tell there's not a leak or ruptured sac, nor cracked section or anything wrong with the personal point threading itself. But rather if the nib/feed was ever repositioned from its original factory setting, the nib tipping and feed may be set too far apart that at certain angles the liquid pools between the gap instead of being controlled by the feed.

From what I can tell from other examples, the feed tip is supposed to be much higher up on the nib.

The sac is the first cause to eliminate because it is the most likely culprit, despite it being new. Bad sacs turn up more than we like, and sometimes the installation can damage the sac. If the symptom persists, the more difficult issue is the feed, especially if you have no replacements handy that fit your section. I am going through this same drippy dilemma with a much-loved oversize '29 Balance that had a months-old sac. One sac later proved it was a bigger issue, and after vain attempts to fit my spare feeds, I had to send it to my penmeister for feed and possibly section re-fitment.

Quote:

---

Originally Posted by FredRydr

The sac is the first cause to eliminate because it is the most likely culprit, despite it being new. Bad sacs turn up more than we like, and sometimes the installation can damage the sac. If the symptom persists, the more difficult issue is the feed, especially if you have no replacements handy that fit your section. I am going through this same drippy dilemma with a much-loved oversize '29 Balance that had a months-old sac. One sac later proved it was a bigger issue, and after vain attempts to fit my spare feeds, I had to send it to my penmeister for feed and possibly section re-fitment.

---

Yep it was the sac, very gummy/squishy, also tacky up by the section nipple, and the side that the pressure bar pushes on was pulled down/exposed (but surprisingly didn't make it into the barrel far as I can tell.

I was in communication with the seller for a couple messages, who was immediately responsive and very upfront, by the time I got his first response I was already in determination mode and had already had the personal point unit out (I told him this), and that I also suspected it was the sac (in his first response he offered a discount if I was confident enough to replace the sac myself, or it could go back to him to be redone, he also offered a full refund to return it if I wish, but as I was already modifying it from it's sold state I told him that I was already determined to keep it).

I just have to follow up with him to tell him what I found with the sac now that the section is out.

When I originally took out the personal point and got the nib/feed out (for the preparation for repositioning since it was easier at the time than getting the grip out of the barrel [ and was awaiting a response on whether or not he uses a sealant on the grip ])

https://i.imgur.com/0dxx0JH.jpg

And after cleaning that up plus getting the section out and noticing the sac.

https://i.imgur.com/hWawTny.jpg

So guess I need a #20 Latex sac, or I can try my #18 stash of silicone sacs (despite the gas permeability)

The seller may have restored the pen and it filled way back when, but he did so years ago...more than he recalls.

I'm surprised you call for a big No. 20.

Just out of curiosity, does the pen have an aluminum sleeve in the barrel? (Oh, never mind. I see that the section is threaded.)

Quote:

---

Originally Posted by FredRydr

The seller may have restored the pen and it filled way back when, but he did so years ago...more than he recalls.

---

Basically that was so :

Quote:

---

It must have been right on the edge when I tested it. I hadn't used that pen in several years. So, to test it, I just filled and emptied it with water a couple of times. Seeing that it filled and emptied, I assumed it was okay. I must have taken it right to the edge.

Very sorry about that! Sorry you had to go through all these steps to figure it out.

---

Quote:

---

Originally Posted by FredRydr

I'm surprised you call for a big No. 20.

---

PenSacs calls for it in the catalog/guides : https://www.pensacs.com/catalog-and-guide/

Quote:

---

Originally Posted by FredRydr

Just out of curiosity, does the pen have an aluminum sleeve in the barrel? (Oh, never mind. I see that the section is threaded.)

---

Actually it does seem to have a sleeve, the section itself is not threaded it's friction fit, and when I look in side I see a thin lining which I thought was soot/patina but it's too sharp. It starts where the section would end inside. So I was wondering if it had a lining, it's the first I've seen of something like that.

The threaded part is the personal point nib unit, it threads into the section, not into the barrel.

Okay, thanks for that clarification of the threads. Separating the section from that aluminum sleeve can be tough. You're fortunate. Wahl specialist Syd Saperstein sells a special lube or penetrant for that purpose and it did work for me, though I've since been told by another restorer the penetrant is simply "Blaster." I'm not yet familiar with it.

Quote:

---

Originally Posted by FredRydr

Okay, thanks for that clarification of the threads. Separating the section from that aluminum sleeve can be tough. You're fortunate. Wahl specialist Syd Saperstein sells a special lube or penetrant for that purpose and it did work for me, though I've since been told by another restorer the penetrant is simply "Blaster." I'm not yet familiar with it.

---

On mine, where the section goes in, the barrel is just celluloid, but just after where the section would end inside the barrel, the sleeve starts. ie: the lining doesn't cover the entire barrels' length.

https://i.imgur.com/NiAPEWs.jpg

nice!

i really am going to have to add inspired blue to my "someday" list... love those bright blue/turquoise inks...

Quote:

---

Originally Posted by INeedAFinancialAdvisor

nice!

i really am going to have to add inspired blue to my "someday" list... love those bright blue/turquoise inks...

---

It also sheens a bit red in spots depending on paper and wetness (it's on there but harder to see on a scan)

This is a very nice pen and masterly photographed! Congrats.

Very nice pen. One benefit of the liner on these, is that it does protect the celluloid from discoloration due to off-gassing. Beautiful color. Don't know what the model is called, but your add shows the long version. Pretty neat that they move the "Gold Seal" from below the clip to the top of the cap for these shorties. Pretty flashy when its in your pocket (assuming no military pocket flap). Good stuff.

Bob

Quote:

---

Originally Posted by Seattleite

Very nice pen. One benefit of the liner on these, is that it does protect the celluloid from discoloration due to off-gassing. Beautiful color. Don't know what the model is called, but your add shows the long version. Pretty neat that they move the "Gold Seal" from below the clip to the top of the cap for these shorties. Pretty flashy when its in your pocket (assuming no military pocket flap). Good stuff.

Bob

---

I haven't found any specific ads that matches mine exactly, though I do have this one now (an original that I got stashed away in my art portfolio for the time being), which is pretty close to mine, except it has the gold seal below the clip.

https://i.imgur.com/DscWYgg.jpg

Would love to find a matching pencil.

Found a restorable Gold Seal pen on eBay and a couple weeks later, bought a matching pencil. So now I have a sweet, blue set.

https://i.imgur.com/CY36OuD.jpg

Nice, congrats, I have its big brother

https://i.imgur.com/7V8GfOY.jpg

Quote:

---

Originally Posted by Chip

Found a restorable Gold Seal pen on eBay and a couple weeks later, bought a matching pencil. So now I have a sweet, blue set.

https://i.imgur.com/CY36OuD.jpg

---

Very nice. Such bold and even color is really hard to find. I suspect that you have a bit of a mismatch, though, with the high-set "military" clip on the short pen not matching the lower set clip of your full-length pencil. The post above yours features an advertisement which illustrates both sets with clip orientation and length ratio of pen/pencil. This is in no way meant to minimize your beautiful Eversharps. It just gives you cause to hunt down another pen and pencil;)

Bob

Quote:

---

Originally Posted by Seattleite

It just gives you cause to hunt down another pen and pencil;)

---

Somewhere out there, a reverse matching set is waiting... ;)