-
September 25th, 2018, 11:34 AM
#1
FPG Donor ♕
- Rep Power
- 11
Morrison Syringe Filler
I am assuming the syringe part is held on by shellac. But I would appreciate information anyone with knowledge on restoring these. I am also assuming there is a specific size piston seal as well.
-
-
September 26th, 2018, 06:12 AM
#2
Re: Morrison Syringe Filler
-
The Following User Says Thank You to FredRydr For This Useful Post:
RayCornett (September 30th, 2018)
-
September 26th, 2018, 11:07 AM
#3
Re: Morrison Syringe Filler
I have successfully replace the old piston/syringe assembly with a modern (very similar) sold by FPR.
The difference is that this replacement has a slightly smaller diameter, therefore I had to create a "step down" from the existing hard-rubber connector on the pen using a lathe.
Afterwards, I just have to shellac the new piston and it works wonderfully.
-
The Following 2 Users Say Thank You to penwash For This Useful Post:
azkid (September 26th, 2018), RayCornett (September 30th, 2018)
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks