Originally Posted by
Dr.X
I did this by finding a spring of similar diameter to the barrel. Cut a C loop out of it and slipped it to the hole in the lever while it was attached to the pressure bar. then I taped a string to the end of the lever and snaked it through the barrel and out the lever box hole (to help me guide and pull the lever through). The trickiest step was inserting the whole apparatus, especially the C-ring, into the barrel. I found I had to bend it a bit because it was too wide, and then (most importantly) used a thin wooden dowel to push it down into the barrel towards the lever bar opening. It really was not too difficult and it worked like a charm.
Bookmarks