-
April 3rd, 2020, 11:54 AM
#1
Member
- Rep Power
- 0
Section making question
Just starting trying to make my own sections. Do you always do the inside first? What is your fail rate?
-
-
April 4th, 2020, 06:17 PM
#2
Junior Member
- Rep Power
- 0
Re: Section making question
Hi
I tap the OD that goes into the body first. I found that the solid ID gives the tapping operation more stability. Then I drill and tap the ID.
Sent from my iPhone using Tapatalk
-
-
April 4th, 2020, 06:24 PM
#3
Junior Member
- Rep Power
- 0
Re: Section making question
If you are new to pen making have you checked out the International Association of Penturners , IAP.org?
It’s a great forum with amazingly talented pen makers. They are very welcoming. Check them out.
Sent from my iPhone using Tapatalk
-
-
April 4th, 2020, 07:33 PM
#4
Re: Section making question
One of these days, a smart pen maker will offer parts fabricated by 3D printer.
-
-
April 11th, 2020, 07:27 PM
#5
Junior Member
- Rep Power
- 0
Re: Section making question
I’ve seen some printed parts. There is a pen maker that creates honeycomb patterns then casts over them. I’ve also seen pen sections.
Sent from my iPhone using Tapatalk
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks