Is there anything you can use to make your own pressure bars? Aluminum? Brass? this: http://www.etsy.com/listing/24187321...ion0=733600266 What gauge wire? Thanks in advance.
Is there anything you can use to make your own pressure bars? Aluminum? Brass? this: http://www.etsy.com/listing/24187321...ion0=733600266 What gauge wire? Thanks in advance.
The cheap pressure bars are one piece with a ridge stamped down the middle. The good ones have a flat spring, and then a shallow U-channel as the actual pressure bar. The spring itself is best with phosphor bronze or spring steel.
When I was first starting to repair pens, I used to repair the old pressure bars using the original channel, and a new spring. Once the reproduction replacements became readily available, I quit repairing them or making them, and have never looked back. Youinvestwaste a heck of a lot of time to save 5 bucks.
Dale Beebe at pentooling.com has quite a selection of sizes and types available.
Visit Main Street Pens
A full service pen shop providing professional, thoughtful pen repair....
Please contact us by email, and not PM for repair inquiries.
Bookmarks