Results 1 to 2 of 2

Thread: Anonymous pen seeking section

  1. #1
    Senior Member
    Join Date
    Dec 2020
    Location
    Suffolk, UK
    Posts
    321
    Thanks
    8
    Thanked 93 Times in 55 Posts
    Rep Power
    4

    Default Anonymous pen seeking section

    Good evening everyone, amongst the pens I got at an auction there was this cute little pen which was mounting a Conway Stewart writing unit held in place by a piece of cardboard and a bit of shellac.
    I removed unit and the shellac from the barrel and am now asking for your advice on where to look for the 'correct' writing bit. The pen has no brand imprint anywhere. The inner barrel diameter, measured where the section should fit, is 8 mm.
    The pen is transparent, plastic? The lever moves perfectly and is still very springy.
    The few nib assemblies I have are either bigger or have threads. Ideas?

    wii1.jpeg wii2.jpeg

    Thank you
    Marco

  2. #2
    Senior Member eachan's Avatar
    Join Date
    Aug 2020
    Location
    Highlands of Scotland
    Posts
    507
    Thanks
    1,442
    Thanked 868 Times in 341 Posts
    Rep Power
    4

    Default Re: Anonymous pen seeking section

    Even with that interior barrel diameter that's really too difficult. If you care to send it to me, that would make it easier to complete the pen from my spares. I won't charge you, apart from return postage. If you want to try that, contact me in private messages

  3. The Following 6 Users Say Thank You to eachan For This Useful Post:

    Chrissy (December 17th, 2021), da vinci (December 16th, 2021), elaineb (December 16th, 2021), jeffj (December 16th, 2021), KBeezie (December 16th, 2021), Schaumburg_Swan (December 16th, 2021)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •