-
December 16th, 2021, 09:23 AM
#1
Senior Member
- Rep Power
- 4
Anonymous pen seeking section
Good evening everyone, amongst the pens I got at an auction there was this cute little pen which was mounting a Conway Stewart writing unit held in place by a piece of cardboard and a bit of shellac.
I removed unit and the shellac from the barrel and am now asking for your advice on where to look for the 'correct' writing bit. The pen has no brand imprint anywhere. The inner barrel diameter, measured where the section should fit, is 8 mm.
The pen is transparent, plastic? The lever moves perfectly and is still very springy.
The few nib assemblies I have are either bigger or have threads. Ideas?
wii1.jpeg wii2.jpeg
Thank you
Marco
-
-
December 16th, 2021, 11:05 AM
#2
Senior Member
- Rep Power
- 4
Re: Anonymous pen seeking section
Even with that interior barrel diameter that's really too difficult. If you care to send it to me, that would make it easier to complete the pen from my spares. I won't charge you, apart from return postage. If you want to try that, contact me in private messages
-
The Following 6 Users Say Thank You to eachan For This Useful Post:
Chrissy (December 17th, 2021), da vinci (December 16th, 2021), elaineb (December 16th, 2021), jeffj (December 16th, 2021), KBeezie (December 16th, 2021), Schaumburg_Swan (December 16th, 2021)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks