Results 1 to 1 of 1

Thread: Button fillers : determining the length of the pressure bar upfront.

  1. September 16th, 2013, 02:33 AM #1
    Fountainbel
    Fountainbel is offline
    Member
    Join Date
    May 2012
    Location
    Belgium
    Posts
    68
    Thanks
    22
    Thanked 196 Times in 40 Posts
    Rep Power
    12

    Default Button fillers : determining the length of the pressure bar upfront.

    Hi all,
    Most people determine the length of the pressure bar gradually by "cut a little and check"
    Drawback being the pressure bar gets easily deformed permanently when installing a "too long" pressure bar.
    Attached a sketch which allows determine the length upfront, after taking some measures of the barrel, section and button.
    Hope this helps !
    Regards, Francis
    Last edited by Fountainbel; September 16th, 2013 at 02:38 AM.
    Reply With Quote Reply With Quote

  2. The Following 3 Users Say Thank You to Fountainbel For This Useful Post:

    cwent2 (September 21st, 2013), gbryal (September 8th, 2014), Jeph (February 3rd, 2014)
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules