Results 1 to 11 of 11

Thread: Original Eversharp Skyline: a good "starter" pen

  1. #1
    Senior Member welch's Avatar
    Join Date
    Aug 2013
    Location
    New York City
    Posts
    559
    Thanks
    904
    Thanked 276 Times in 183 Posts
    Rep Power
    8

    Default Original Eversharp Skyline: a good "starter" pen

    People often ask "What pen should I get now that I've written enough with my Lamy Safari to understand why a fountain pen is wonderful". Before spending $100 or $200 on a good modern pen, consider one of the "vintage" pens, the original Eversharp Skyline.

    - The Skyline had some of the best nibs of all time. Most of the Skylines I have gotten -- mostly in raw state from EBay -- have had a soft nib. Not a flex nib for writing elegant swirly "spencerian" works of art, but a comforting soft nib with just the right amount of "give". Yes, a better nib than you can buy on the Montblance 146, which is a pretty fair nib (although pricy). I think Eversharp had some sort of magic spell they used on their nibs.

    - Eversharp did not experiment with exotic and complex filling systems. (They left that to Parker and Sheaffer). Instead, the Skyline has a simple lever-and-sac. The benefit is that it is easy to replace a Skyline sac. You can assume that a Skyline will need a new sac unless someone has replaced it...but that's not rocket science or as difficult as repairing a Snorkel. Just wiggle the "section" and nib out of the barrel, clean out any scraps of dead sac, then brush some shellac on the section "nipple" and pull the sac over the nipple. Let the shellac dry, and then roll the new sac/section/nib in talc. Shellac is about $5 from pen repair sites: Pendemonium, Brian and Lisa Anderson, Richard Binder, Ron Zorn, and many others I don't have time to remember and name. Talc is a few dollars for more talc than you will use in a life-time...unless you go into pen repair, or unless you use it for billiards (the most typical use). I find it handy to use "section pliars" to hold the barrel and section as I separate them, and I use a "section spreader" to stretch the sac wide enough to fit iver the sac nipple. More experienced repair people don't bother with a sac spreader, but they do this for a living.

    - The Skyline's "plastic" has become brittle. (You'll be brittle, too, after 70 years!). No big deal: be careful, but Skylines often sell between $15 and $40, so you can afford a few "oops" pens.

    - I usually hand-polish a Skyline with sunshine cloth.

    - Result: a pen from the mid-40s that will delight your hand when you write, and will not cause you to take out a bank-loan to buy it.

    The Skyline was, briefly, the best-selling pen in the US. There are many just waiting to be refursbished. Go to it!

    Incidentally, Syd "The Wahlnut" Saperstein has bought the right to Eversharp and its product line. If you like the original Skyline, you might start saving to buy one of the new Skylines: a cartridge / converter pen built close to the specs of the old Skyline. I believe new Skyline caps will even fit an old Skyline pen. The new Wahl (corporate name for Eversharp) is committed to developing nibs that give as much pleasure as the old Skyline nibs. That's a tough standard to meet, but it shows that the new Wahl is serious.

    (No, I don't work for the new Wahl, and haven't saved enough to buy one of their pens. Someday, though...)

  2. The Following 4 Users Say Thank You to welch For This Useful Post:

    earthdawn (January 3rd, 2014), Jeph (January 2nd, 2014), Jon Szanto (January 2nd, 2014), kaisnowbird (January 3rd, 2014)

  3. #2
    Senior Member
    Join Date
    Aug 2013
    Location
    San Francisco Bay Area, Calif, USA
    Posts
    585
    Thanks
    7
    Thanked 197 Times in 139 Posts
    Rep Power
    8

    Default Re: Original Eversharp Skyline: a good "starter" pen

    My first skylines were parts pens from an estate sale.
    The sac replacement was my first sac replacement and it went very smooth. Reading and preparing to do the sac replacement took longer than doing the actual sac replacement.
    A kind friend donated a couple of feeds to replace the missing feeds.
    And once put together, I was very surprised at how well the Skylines wrote. So SMOOTH

    Besides being brittle, the plastic shrinks.
    One of the caps has a loose band, because the plastic cap shrank.

  4. #3
    Senior Member
    Join Date
    Dec 2013
    Location
    Chicago area
    Posts
    170
    Thanks
    0
    Thanked 93 Times in 61 Posts
    Rep Power
    8

    Default Re: Original Eversharp Skyline: a good "starter" pen

    Now, if I could only find a Skyline Executive for $15-40. . .

    I had to shell out a lot more than that, several years ago, to latch onto an Executive. What a pen! Mine isn't perfect, but I think the "cool factor" beats my 149 by a long shot.

  5. #4
    Junior Member
    Join Date
    Dec 2013
    Posts
    11
    Thanks
    0
    Thanked 19 Times in 10 Posts
    Rep Power
    0

    Default Re: Original Eversharp Skyline: a good "starter" pen

    Just a reminder that some Skylines had breather tubes that can make resacing a little more than straight forward.

  6. The Following User Says Thank You to Norm Matthews For This Useful Post:

    reprieve (January 6th, 2014)

  7. #5
    Senior Member welch's Avatar
    Join Date
    Aug 2013
    Location
    New York City
    Posts
    559
    Thanks
    904
    Thanked 276 Times in 183 Posts
    Rep Power
    8

    Default Re: Original Eversharp Skyline: a good "starter" pen

    Quote Originally Posted by Norm Matthews View Post
    Just a reminder that some Skylines had breather tubes that can make resacing a little more than straight forward.
    Ah, Norm, you've caught my laziness!

    My "lazy person's guide to repairing a lever-filler" says that if I find a breather tube, I use it. I carefully stretch the sac asround the tube. If no tube, I don't bother scratching around to make one. Memory says I once asked Ron Zorn if a breather tube was necessary, and he asked if I had seen a sac-pen without one. Sure: Esterbrooks do not have a breather-tube.

    For anyone who has not seen one, a breather tube is about the thickness of the red tube that comes with WD-40. It fits into the section, and allows a user to pull more ink into a sac as the inside of the empty sac wants to be the same air-pressure as outside. Instead of one squeeze of ink, the pen gets several. At least that's my amateur's explanation.

  8. #6
    Senior Member
    Join Date
    Aug 2013
    Location
    San Francisco Bay Area, Calif, USA
    Posts
    585
    Thanks
    7
    Thanked 197 Times in 139 Posts
    Rep Power
    8

    Default Re: Original Eversharp Skyline: a good "starter" pen

    I got my breather tube from David Nishimura @ vintagepens.com
    5 feet is way more than I can every see using, so I don't worry about it if I make a mistake, I throw it away and make a new one.

    One of mine still had the breather tube, so I made the new breather tubes the same (length and shape).
    Last edited by ac12; January 6th, 2014 at 01:31 PM.

  9. #7
    Senior Member
    Join Date
    Dec 2013
    Location
    Chicago area
    Posts
    170
    Thanks
    0
    Thanked 93 Times in 61 Posts
    Rep Power
    8

    Default Re: Original Eversharp Skyline: a good "starter" pen

    Also, bear in mind that if a pen is designed to have a breather tube, if you leave the tube out the pen may not fill completely. I've found this to be the case with Skylines. In a pinch, I have used a modified "straw" from a can of WD-40. . .
    Last edited by SteveE; January 9th, 2014 at 06:39 AM. Reason: spellong. . .

  10. #8
    Senior Member reprieve's Avatar
    Join Date
    Apr 2013
    Location
    just a little bird floating on a hurricane
    Posts
    958
    Thanks
    1,791
    Thanked 987 Times in 439 Posts
    Rep Power
    9

    Default Re: Original Eversharp Skyline: a good "starter" pen

    I have a green striped Skyline, which was one of my first vintage pens, purchased several years ago from a member on FPN. It has a lovely flexible nib and a convenient little ink window and I find the tapered barrel to be very ergonomic.

    I agree with you--I think the Skyline is a great introduction to vintage pens, and it's one that doesn't often get mentioned.

  11. #9
    Junior Member
    Join Date
    Dec 2013
    Posts
    8
    Thanks
    1
    Thanked 1 Time in 1 Post
    Rep Power
    0

    Default Re: Original Eversharp Skyline: a good "starter" pen

    I just purchased my first skyline from a local seller. I love it. It writes so smoothly and looks really cool to boot. I wonder if one upside of the whole brittle plastic thing is that the nib--the real reason I was interested in the pen--survives to be in another pen. I bet there are a lot of nice skyline nibs floating around out there from broken pens.

  12. #10
    Junior Member
    Join Date
    Mar 2014
    Posts
    17
    Thanks
    1
    Thanked 2 Times in 2 Posts
    Rep Power
    0

    Default Re: Original Eversharp Skyline: a good "starter" pen

    Mine had the "lucky curve" looking breather tube. I removed and replaced it...i saved the old tube. It was pretty easy.

  13. #11
    Senior Member welch's Avatar
    Join Date
    Aug 2013
    Location
    New York City
    Posts
    559
    Thanks
    904
    Thanked 276 Times in 183 Posts
    Rep Power
    8

    Default Re: Original Eversharp Skyline: a good "starter" pen

    I have found that the Skyline sections are more durable than the caps and barrels. Also found that many pens of the late '30s and '40s had roughly the same diameter sections. I think it is perfectly OK to put an orphaned Skyline nib/section on anything that will take it. Yes, the result is a franken-pen, but any pen with an Eversharp Skyline nib is a fine pen.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •