Once I had decided on the colours I cut out a back panel I tried to cut out the shape and punch the holes for stitching to save time later but this failed and I had to start over.

I cut a replacement panel and shaped a piece of kydex to form the back support. I covered it in the red suede ready to join the two pieces together.

20170911_132122[1] by my0771, on Flickr

After the trial fit of the front and back panel I added some glue to hold the pieces while I made the stitching holes and stitched the case together.

20170911_175609[1] by my0771, on Flickr

when the glue had dried I removed all of the clips and positioned the strap.

20170911_194112[1] by my0771, on Flickr

Stitching finished

20170912_210935[1] by my0771, on Flickr

Trimming was next.

20170913_073635[1] by my0771, on Flickr

After trimming I sanded the edges and dyed them the same colour as the rest of the case.

20170913_085254[1] by my0771, on Flickr

20170913_085403[1] by my0771, on Flickr

Thanks for looking

Michael